The next storm could leave the same leg pad buried under 6″ of sand. There is no way to prevent this from happening. Even with a properly installed dock, a storm can move the sand at any time. It is not uncommon for storms to “wash out” the sand from under the footpads. Try to “wiggle” the legs around and re-tighten the bolts, if needed. Now, push up on the dock frame and tighten one bolt and then the second bolt. When you loosen the bolts, the legs will fall until the footpads hit bottom. ![]() While standing in the water, loosen both bolts on only the affected leg. If this is the case, the legs need adjustment. If you are in a sandy area, the water may have washed the sand out from under the footpads. It’s rare, but occasionally one of them is not touching the bottom. If the bolts are tight on the dock legs, the problem is at the bottom of the legs. Are the bolts loose in the affected area? The simplest way to check for the cause is to check the bolts that lock the legs. The problem should affect only one side of the dock. Usually, you will sense the bounce in one area along the dock length. Loose bolts on the dock frame in the leg pockets. A leg is no longer in contact with the lake bottom orĢ. ![]() VERTICAL MOVEMENT (BOUNCE) HAS TWO POSSIBLE CAUSES:ġ. As you may have noticed, the sensation is more noticeable when you walk near a dock leg. Vertical movement gives you a “spongy” bounce as you walk on the deck. ![]() These have different symptoms, and both have different solutions. But, we need to distinguish between vertical movement and horizontal movement. HOW CAN THE MOVEMENT BE MINIMIZED?īefore we can answer that question, there’s an important question you must answer. Due to the deep water and stronger storms, it is necessary to raise your dock to protect your equipment. Movement or ” dock sway” is the result of deeper water.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |